SV: Insert 3th NIC to route Subnet

Well... if I understand you correctly, then your rules should look like:

Rules 3rd NIC : Allow * 3rd NIC * * *
Rules LAN :  Allow * LAN net * * *

After that put your computer on one NIC and ping the router address  (gatew=
ay) of the other NIC. If you get a reply then you should be OK.

For example:
3rd NIC IP address: 10.10.10.1
LAN NIC IP address: 192.168.1.1

If you connect your computer to LAN NIC and your computer get the address 1=
92.168.1.100, then try to ping 10.10.10.1. If you get a reply you should be=
 able to reach the 3rd NIC network. If no reply then you've overlooked some=
thing.

/D



-----Ursprungligt meddelande-----
Fr=E5n: [email protected] [mailto:Dennis.Riemenschn=
[email protected]]
Skickat: den 25 april 2014 11:49
Till: Daniel Jokinen
Kopia: [email protected]
=C4mne: AW: Insert 3th NIC to route Subnet

Dear Daniel.

No i have enabled the  3th NIC.

Rules 3Th NIC : * * * * *
Rules LAN :  * LAN net * * *

That's correct ?

Best wishes

Dennis


-----Urspr=FCngliche Nachricht-----
Von: Daniel Jokinen [mailto:[email protected]]
Gesendet: Freitag, 25. April 2014 11:23
An: Riemenschneider, Dennis
Betreff: SV: Insert 3th NIC to route Subnet

A normal "allow all" rule on both networks should allow traffic between the=
m. Simply add an allow rule on each interface, allowing any outgoing traffi=
c with any protocol. You need this to access internet too, so it's almost s=
tandard in all configs.


/D




-----Ursprungligt meddelande-----
Fr=E5n: [email protected] [mailto:Dennis.Riemenschn=
[email protected]]
Skickat: den 25 april 2014 11:15
Till: [email protected]
=C4mne: [m0n0wall] Insert 3th NIC to route Subnet

Dear all.

Next to my normal Network i want to route an 10.x.y.z /24 network. So I ins=
ert a 3th NIC . So which rules I have to insert that I a connection from my=
 normal network to the 10.x.y.z and the way back ?

Best wishes

Dennis