Re: PCEngines APU Support

Fernando> Are these new boards supported by m0n0wall 1.8.1?
Fernando> Which image is recommended?

I'm running one right now and the performance is good.  You need to
use the generic PC over serial image.  The BIOS runs at 115200 baud,
but m0n0wall runs at 9600.  Or visa-versa.  Can't remember and I'm not
home to double check.

Quick note, the interfaces are re0, re1 and re2.  They start next to
the DB9 on the board and move towards the power supply input.

And there's a problem with the BIOS on the boards, it doesn't properly
support the LEDs on the ethernet ports, esp if you unplug and re-plug
while the board is running.  There's something wrong in there that
PC-engines know is a problem, but haven't released a fix.  They
basically say that the docs from Realtek suck.

Hopefully this will be addressed in time.  

John