Re: minimum requirements
"Harry Chester" <hjc-+m/[email protected]> Thu, 11 Nov 2004 10:59:54 -0000
| Newsgroups | gmane.comp.security.firewalls.smoothwall.general |
|---|---|
| Message-ID | <000f01c4c7dd$93a5c130$0200a8c0@hjc> |
----- Original Message ----- From: "Martin Pot" <mpot-/[email protected]> To: <[email protected]> Sent: Wednesday, November 10, 2004 10:43 PM Subject: Re: [gpl] minimum requirements > On Wed, 10 Nov 2004, Stuart Munro wrote: > >> I am looking to start using smoothwall, but I havent found min >> requirements, will a 600 p3 w/512 ram work or should I do a 1 gig. > > FYI, the minimum and recommended hardware specs are clearly listed on > http://www.smoothwall.org/ > Have a look at the wording at the bottom of the large orange bar which is > across the top of the page. I've 128Mb ram with virtually everything enabled, and it starts to use the swap file within a day or two, from what I've read on this list in the past 512Mb appears to be more than enough not to require using the swap file. I appreciate this may depend on the amount of users/computers behind Smoothwall, otherwise it runs great on a 350Mhz AMD K6 with 3GB disk. Harry Chester > > Cheers, > Martin. > http://martybugs.net > _______________________________________________ > gpl mailing list > [email protected] > http://lists.smoothwall.org/mailman/listinfo/gpl > > SmoothWall Stash - Buy Our Stuff! http://cafepress.com/smoothwall _______________________________________________ gpl mailing list [email protected] http://lists.smoothwall.org/mailman/listinfo/gpl SmoothWall Stash - Buy Our Stuff! http://cafepress.com/smoothwall