Re: Cisco AnyConnect Remote Access to L2L tunnels

I am pretty sure one of the two session discussed that.

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Virtual%20Private%20Networks&topic=Security&topicID=.ee6b2b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc18a4d

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Virtual%20Private%20Networks&topic=Security&topicID=.ee6b2b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc16976

Schiling

On Wed, Jun 10, 2009 at 2:17 PM, Todd Simons<[email protected]> wrote:
> Hello All
>
> We are using the Cisco AnyConnect Client for our remote user’s access, with
> a global tunnel.   Internally we have a few corporate locations that are
> linked by L2L tunnels (lets call it Site A, Site B and Site C).   The Remote
> Access clients who connect to Site A can’t seem to use the L2L to Site B and
> Site C.
>
> Has anyone seen a document explaining how to do this?
>
> Todd Simons
>
> Lead IT Engineer
>
> [email protected]
>
>
>
> Delphi Technology, Inc.
>
> 303 George Street, 5th Floor
>
> New Brunswick, NJ  08901
>
> www.delphi-tech.com
>
>
>
> Experience, Innovation... Results.
>
> ## Scanned by Delphi Technology, Inc. ##
>
> CONFIDENTIALITY NOTICE
> This e-mail message from Delphi Technology, Inc. is intended only for the
> individual or entity to which it is addressed. This e-mail may contain
> information that is privileged, confidential and exempt from disclosure
> under applicable law. If you are not the intended recipient, you are hereby
> notified that any dissemination, distribution or copying of this
> communication is strictly prohibited. If you received this e-mail by
> accident, please notify the sender immediately and destroy this e-mail and
> all copies of it.
>
> _______________________________________________
> firewall-wizards mailing list
> [email protected]
> https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
>
>