Re: VPN and XP Firewall GPO settings

Sorry, I may have explained badly so just to clarify:

Our default GPO is set to enable the XP Firewall when the laptops are  
on "Standard Profile" and disable it when using "Domain  
Profile" (going from "netsh firewall show currentprofile").

What seems to happen is laptop is using public wi-fi, so it's on  
"Standard Profile", firewall is enabled.

User connects using Network Connect.

XP does a GPUpdate and because it can reach the domain controllers  
seems to assume "Oh I'm on the domain" and switches to Domain Profile  
and switches off the firewall on the client.

I could configure a GPO just for laptops that keeps the firewall on  
regardless, but I'm trying to ascertain whether what I'm seeing is  
normal or not?

Also what (if any) mitigation does disabling split tunnelling so the  
VPN client can't see/be seen even on the local subnet have?

Cheers,
Paul

On 22 Jun 2009, at 17:01, Victor Williams wrote:

> We have our GPO's set to have the firewall on, with the only  
> exception being tcp port 139 and 445 can be accessed by our domain  
> controllers.  Would a setup like this not work?
>
> All of our VPN clients work with the Microsoft XP firewall turned  
> on without issue.  We use the Cisco IPSec client as well as the  
> AnyConnect VPN client.  No issues with either.
>
> The XP firewall by default allows any outgoing traffic, and no  
> incoming unless you so specify.  I'm not sure why it would be  
> blocking your outgoing VPN traffic originating from your  
> workstations.  If it is, you should be able to make an exception  
> related to the actual VPN executable allowing it outgoing access,  
> and leave the firewall on all the time, regardless of what network  
> it's connected to.
>
>
> ---- Paul Hutchings <[email protected]> wrote:
>> Folks hoping for a little input here:
>>
>> We have a Juniper SSL VPN that has Network Connect functionality.  We
>> have our Group Policies configured so that when onsite XP firewall is
>> disabled, when offsite XP firewall is enabled.
>>
>> It seems what's happening when people use the Network Connect
>> functionality of the VPN is that XP is detecting that it has
>> connectivity to the LAN and the domain controllers/DNS boxes and is
>> switching from the "Standard Profile" to the "Domain Profile" and
>> dropping the firewall, which is of course unacceptable (I accept it's
>> behaving by design so it's not really a criticism of Microsoft).
>>
>> What do people do to work around this kind of issue?  I guess a group
>> policy for laptops that enables the firewall even when on the domain
>> is one option, and I've opened a case with JTAC in case I'm missing
>> something on the SA config.
>>
>> Thanks.
>> _______________________________________________
>> firewall-wizards mailing list
>> [email protected]
>> https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
>