RE: HoneyD-Win32 Parse Error --- ROADBLOCK

Also, I am not sure you can use a multi work template name. try the template
name Windows_98 and see what happens.

Create Windows_98
Annotate "Windows 98"
Set Windows_98 Personality "Windows 98"
BIND 1.1.1.1 Windows_98

Thanks,
Michael A. Davis
Chief Executive Officer
Savid Technologies, Inc.
Main: 708.243.2850
http://www.savidtech.com

This email may contain confidential and privileged information for the sole
use of the intended recipient. Any review or distribution by others is
strictly prohibited. If you are not the intended recipient, please contact
the sender and delete all copies of this message. 

> -----Original Message-----
> From: Wren Mott [mailto:[email protected]] 
> Sent: Wednesday, June 22, 2005 4:42 PM
> To: [email protected]; [email protected]
> Subject: HoneyD-Win32 Parse Error --- ROADBLOCK
> 
> Hi Roger -
> 
> First of all thank you for writing your book.  After weeks of 
> research I finally ran across it and it put all of the pieces 
> together for me.
> Well, almost all of the pieces.
> 
> I have installed HoneyD-Win32 as described in your book and 
> if I simply run the command "honeyd -d" it pops up and says 
> it is listening.  I can even see it catch traffic!  Woo hoo!
> 
> The problem is when I try to feed it a config file.  Even the 
> most simplest of configurations give me a PARSE error.  For example:
> 
>  
> 
> Create Windows 98
> Annotate "Windows 98"
> Set Windows 98 Personality "Windows 98"
> BIND 1.1.1.1 Windows 98
> 
> I even double checked to make sure that "Windows 98" was 
> defined in my nmap.prints file.
> 
> Any idea where I can go from here?  I feel like I'm steps 
> away from the holy grail but the final inches are stretching 
> into miles.
> 
> 
> Regards,
> 
> Wren
> 
> Sr. Consultant
> Prosum Technology Group
> 
>