[Prelude Hybrid IDS] #160: How to : Change prelude-lml Location
Prelude Hybrid IDS <[email protected]>
| Newsgroups | gmane.comp.security.ids.prelude.devel |
|---|---|
| Message-ID | <[email protected]> |
#160: How to : Change prelude-lml Location
-------------------------+--------------------------------------------------
Reporter: anonymous | Owner: yoann
Type: defect | Status: new
Priority: normal | Milestone:
Component: prelude-lml | Version: 0.9
Severity: normal | Keywords:
-------------------------+--------------------------------------------------
Hi, everyone.
I have an obvious question for you.
I installed all the differents prelude's libs, dependencies etc...
Prewikka too.
Everything is allright, running on the localhost. But now i'm trying to
set up prelude-lml in order it to analyze an other network interface.
So I configured this new network named "eth1" and it receives a network
stream. I want to analyze this one.
I tryed to set all the *.conf files of prelude in order prelude-lml to
analyze this interfacebut it doesn't work at all. Can someone check and
summarize the differents changes I should do ?
Thanks for all. John
--
Ticket URL: <https://trac.prelude-ids.org/ticket/160>
Prelude Hybrid IDS <http://www.prelude-ids.org>
The Prelude Hybrid Intrusion Detection System suite
_______________________________________________
Prelude-devel site list
[email protected]
http://www.prelude-ids.org/mailman/listinfo/prelude-devel