Re[2]: explicit guide on how to setup a public node on Linux

Hi Lars,

Wednesday, November 12, 2003, 11:27:13 PM, you wrote:

LS> Lance James wrote:

>> LS> I tried to setup a public node for IIRC.
>> LS> But after set it up and starting I see no traffic on the PC nor a try
>> LS> for a connect, nor my node in the node.ref.
>> it can take up to 5 days to be an active node in the network. If you
>> can connect to IIP, that's the good part.

LS> Good to know. yes, I can connect to IIRC with my machine, and I want to
LS> become a (stable) node, so I wonderd.
LS> But 5 days is hell a lot of time. And if it finally works out, it'll be
LS> very good for the network.

>> LS> Can anybody type a explicit list for setting up a node with isproxy 1.1.0 ?
>> That can be done.

LS> Lets see if I can do parts of them. The Wiki wasn't clear in some parts,
LS> so I think about changing some lines, hey, it's a wiki, we all can do it.

>> LS> And why is in the listen.ref the IP = 127.0.0.1 ? shouldn there be my IP?
>> did you select to be a public node and put in your ip address?
>> listen.ref just binds your ports for listening on. And at this state
>> you are 127.0.0.1 to your computer.

LS> As I said before, the Wiki wasn't clear enough for me. NOW I learned,
LS> the listen.ref is the config file for the proxy, NOT for the node. So
LS> 127.0.0.1 is right for it (or any other IP you want to listen to).

LS> A GOOD question at last:
LS> Are there more nodes than on the node.ref list?
there are more nodes than on the first node.ref you get with the
software yes. it's dynamically updated.


LS> Cya
LS> Lars



-- 
Best regards,
 Lance James                          mailto:lance-I6tsvYnOiqa1tQ18MUY/[email protected]
Secure Science Corp.
www.securescience.net


_______________________________________________
iip-dev mailing list
[email protected]
http://lists.invisiblenet.net/mailman/listinfo/iip-dev