Re: IPCop 2 SVN Impossible to manually add fixed lease.
Olaf Westrik <weizen_42-Yz37vSk3/[email protected]>
| Newsgroups | gmane.comp.security.ipcop.devel |
|---|---|
| Message-ID | <[email protected]> |
On 2011-03-28 22:48, David W Studeman wrote: > Olaf Westrik wrote: > >> On 2011-03-27 23:54, David W Studeman wrote: >> >>>> I think dhcp.cgi checks to see if the IP address is within the subnets >>>> of the interfaces on IPCop. I would guess that 192.168.5.0 is not one >>>> of your IPCop's/Raccop's networks? >>> >>> Actually yes, it is used on green. >> >> The IP address must be 'within range' and DHCP must be enabled on that >> interface. > OK. When setting up a backup router such as 3G in case my DSL goes down, I > like to pre-populate the fixed leases without dhcp enabled. It sounds like I > am the only one who ever does this. At least I know now. I'll remove the additional test. IIRC I added the DHCP server enabled test to avoid a dnsmasq error, tried again yesterday and there are no complaints from dnsmasq. Should there be problems, we can always readd the test, after all we are still in Beta ;-) Olaf ------------------------------------------------------------------------------ Enable your software for Intel(R) Active Management Technology to meet the growing manageability and security demands of your customers. Businesses are taking advantage of Intel(R) vPro (TM) technology - will your software be a part of the solution? Download the Intel(R) Manageability Checker today! http://p.sf.net/sfu/intel-dev2devmar