Re: Traverse Solos PCI and Bonding.

----- Original Message ----- 
From: "David W Studeman" <[email protected]>
To: <[email protected]>
Sent: Thursday, April 28, 2011 10:31 PM
Subject: [IPCop-devel] Traverse Solos PCI and Bonding.


> Hello. Some of you may remember that I acquired a Traverse Solos Four Port
> ADSL modem and am wanting to integrate it into IPCop 2. So far the driver
> and the cli utility are integrated after Olaf submitted them.
>
>  I found an isp that does bonding and include static addresses with them.
> IPCop svn already has the bonding driver but does not include ifenslave. I
> found this example on how to do it:
> modprobe bonding
> ifconfig bond0 194.54.32.13 netmask 255.255.255.252
> ifconfig nas1 up
> ifconfig nas2 up
> ifenslave bond0 nas1
> ifenslave bond0 nas2
>
> ifenslave.c is in the kernel documentation but the bonding documentation
in
> the same folder mentions that you do not need ifenslave if you are going
to
> use sysfs to accomplish this. Ifenslave is certainly not a new program.
Any
> ideas on the best way to end up with bond0 which enslaves multiple nas'es?
> -- 
> Dave
> http://www.raqcop.com
>
>
googling for 'sysfs bond0 linux' show
first : http://lwn.net/Articles/142330/ which was a 2.6.13 patch
second : linux Documentation/network/bonding.txt should be more up to date
chap 3.4 Configuring Bonding Manually via Sysfs

Gilles



------------------------------------------------------------------------------
WhatsUp Gold - Download Free Network Management Software
The most intuitive, comprehensive, and cost-effective network 
management toolset available today.  Delivers lowest initial 
acquisition cost and overall TCO of any competing solution.
http://p.sf.net/sfu/whatsupgold-sd