| Newsgroups |
gmane.comp.security.ipcop.user |
| Message-ID |
<[email protected]> |
On 12/07/16 15:30, G.W. Haywood wrote:
> Hi there,
>
> On Tue, 12 Jul 2016, stinga wrote:
>
>> >... I can't get squid proxy to work on eth0/1, what am I missing?
> Disclaimer: I don't use squid much. Maybe in the squid configuration
> file you need a couple of 'listen' directives (and then quite likely
> 'acl' directives), for the interfaces.
After much jiggery pokery, I managed to get it to work.
Not sure what I did, but I believe the key is adding extra rules to
allow eth0 access to internal ipcop.
ntp
domain
dhcp - source 0.0.0.0
proxy-int-1
This now means the kids can have different squidguard rules to the
adults as they are on a separate network
Also need to allow ip traffic in the proxy config.
My eth0 AP is a raspberry pi, with ebtables so I can track download
allowance and time. Just drop allow rules when time/allowance is up.
--
'ooroo
Stinga...(:)-)
---------------------------------------------------
Email: [email protected] o
You need only two tools. o /////
A hammer and duct tape. If it /@ `\ /) ~
doesn't move and it should use > (O) X< ~ Fish!!
the hammer. If it moves and `\___/' \) ~
shouldn't, use the tape. \\\
---------------------------------------------------
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports.http://sdm.link/zohodev2dev
_______________________________________________
IPCop-user mailing list
[email protected]
Manage your subscription or unsubscribe
https://lists.sourceforge.net/lists/listinfo/ipcop-user