cmd line arguments

"arthur" <[email protected]> Tue, 17 Jun 2008 15:28:27 -0400

Newsgroups	gmane.comp.security.nessus.general
Message-ID	<[email protected]>

After scan IP and port by nmap, I want to use Nessus to scan this given ip&port. However I'd like to:

1. scan in a batch file instead of using NessusClient
2. scan with all available plugins (even I know the target is Solaris10 behind a cisco fw)
3. scan this port as SSL port (is these already covered by #2?)
4. output report in either txt or html

Should I use nessuscmd? How can I set #2/3/4 in the cmd line?

Thanks,

Arthur

_______________________________________________
Nessus mailing list
[email protected]
http://mail.nessus.org/mailman/listinfo/nessus