CrossCompile - mmap - arm
Kris Armstrong <[email protected]>
| Newsgroups | gmane.comp.security.nmap.devel |
|---|---|
| Message-ID | <[email protected]> |
HI, First let me state I am new to this and could use some guidance I am attempting to cross compile nmap 7.40 for arm and create a static nmap binary. The binary is created successfully; however, it remains dynamic. I’m not sure where to go from here. Here are the commands used and the output of a file ./configure --host=arm-linux-gnueabi --without-subversion --without-liblua --without-zenmap --with-pcre=/usr --with-libpcap=included --with-pcap=linux --with-libdnet=included --without-ndiff --without-nmap-update --without-ncat --without-liblua --without-nping --without-openssl make static make install file nmap nmap: ELF 32-bit LSB executable, ARM, EABI5 version 1 (SYSV), dynamically linked, interpreter /lib/ld-linux.so.3, for GNU/Linux 3.2.0, BuildID[sha1]=58ed7ba79660d8ceb0f3f5ce57fec7687d083a2d, not stripped Questions. Is it possible to create a fully static binary of nmap? If not how would I find out which libraries are needed. Typically I can run an ldd <binaryname> however the system I am on is x64 so it can’t tell me what binaries are needed for the arm binary _______________________________________________ Sent through the dev mailing list https://nmap.org/mailman/listinfo/dev Archived at http://seclists.org/nmap-dev/