Re: Ncrack telnet module

Hi;

Again thanks for the response. I think I am doing what you suggested. Here's
the latest chatter:

nmap -p 23 --script telnet-brute --script-args "telnet-brute.passonly=true,
passdb=testPasswords.txt" <ip address>

Starting Nmap 7.40 ( https://nmap.org ) at 2017-06-14 18:35 Pacific Daylight
Time

Nmap scan report for <ip address>

Host is up (0.16s latency).
PORT   STATE SERVICE
23/tcp open  telnet
| telnet-brute: 
|   Accounts: No valid accounts found
|   Statistics: Performed 5 guesses in 38 seconds, average tps: 0.1
|_  ERROR: Password prompt encountered

Nmap done: 1 IP address (1 host up) scanned in 40.64 seconds

I think your syntax is slightly different. Trying this too, and nmap does
not return. So at least this is changing the behavior. I will play with this
a bit more.

Thanks, nnposter!






--
View this message in context: http://nmap-dev.996309.n3.nabble.com/Ncrack-telnet-module-tp28740p28744.html
Sent from the Nmap - Dev mailing list archive at Nabble.com.
_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/