Re: nmap question

Marjan,

Thanks for the inquiry! The installer doesn't produce any log messages
currently. We may be able to make it save an installation log, but for
licensees, this would be best handled as a request to the support
address.

Dan

On Fri, Jul 7, 2017 at 11:41 AM, Marjan Marzban
<[email protected]> wrote:
> Hello,
> I am working on installing nmap in silent mode(our company is in the process
> of buying the license) my question is I am going to run windows self
> installer in the silent mode in powershell using $LASTEXITCODE I can check
> if it is successful or not, but I was wondering if there are some log
> messages that I can get from installer?
>
>
> Thanks,
> Marjan
>
> _______________________________________________
> Sent through the dev mailing list
> https://nmap.org/mailman/listinfo/dev
> Archived at http://seclists.org/nmap-dev/
_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/