%! is not a valid Win32 application

Dear NMap Community,

I installed

       https://nmap.org/dist/nmap-7.50-setup.exe

on a Windows XP Pro SP3 machine.  During the install, I
got told that NDIS6 was not supported.  I did not care
as the machine was using NDIS5 drivers.  The install
completed normally.

When I fired it up and ran

     nmap -p [port] --open -PN -sV -oG ssh_hosts [ip or network]

(yes I made the substitutions in the brackets.)

I got back:

      "%! is not a valid Win32 application"

Any words of wisdom?


Many thanks,
-T


-- 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Computers are like air conditioners.
They malfunction when you open windows
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/