About using ncat in Windows

I installed nmap 7.50 both Inte Edison Breakout Board (Linux) and my computer (Windows). It has ncat inside it.



I am using it in Edison as connect mode by typing ncat <host> <port> and it connects properly.



But in Windows, I am trying to connect it as listen mode by typing ncat --listen <host> <port>. It gives this error.



"The requested address is not valid in its context. . QUITTING."



I scanned Edison's IP address by nmap and it returns without any problem.



So do you have any idea about the reason of getting this error?



I am using Windows 10.



Thank you.

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/