Re: MAKE issue on nmap-7.60.tar.bz2

Alison,

Thanks for reporting this! It is indeed a small bug in Ncat, which we found
independently and have fixed in the latest development trunk. The effect is
that the setup function for SSL listening is run regardless of whether Ncat
is in listen mode or not, and regardless of whether SSL has been requested.
Fortunately, this does not have any effect on Ncat's actual operation; it
is simply wasted cycles and extraneous debug output.

Please don't hesitate to let us know if you find any more issues! Thanks,
Dan

On Thu, Aug 3, 2017 at 8:43 AM, Alison M. Wheeler <[email protected]> wrote:

> Hi,
>
> Took the email about the new version as a good reason to install it,
> working from the bz2 source. Configure went through fine, but the make
> hasn't, throwing up the following:
>
> ---
> EN -DHAVE_LUA=1 -I../liblua -g -O2 -Wall -c ncat_listen.c -o ncat_listen.o
> ncat_listen.c: In function ‘ncat_listen_stream’:
> ncat_listen.c:266:5: warning: this ‘if’ clause does not guard...
> [-Wmisleading-indentation]
>      if (o.ssl)
>      ^~
> ncat_listen.c:269:9: note: ...this statement, but the latter is
> misleadingly indented as if it is guarded by the ‘if’
>          setup_ssl_listen();
>          ^~~~~~~~~~~~~~~~
> --
>
> Compiling on Linux 4.8.0-1-amd64 #1 SMP Debian 4.8.7-1 (2016-11-13) x86_64
> GNU/Linux. This was a new/blank install, not an upgrade. Although it threw
> the warning it appears to be running OK so far.
>
>
> Regards,
> Alison
>
> _______________________________________________
> Sent through the dev mailing list
> https://nmap.org/mailman/listinfo/dev
> Archived at http://seclists.org/nmap-dev/

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/