Re: please respond to this?

Michael Wood <[email protected]> Tue, 19 Mar 2019 20:08:14 -0400

Newsgroups	gmane.comp.security.nmap.devel
Message-ID	<CAKKN48xFVoH=nAbf4mESV-moJg8Yoj=hN+b73DsDY5f0LNc=1w@mail.gmail.com>

Never seen that happen before.  I can assure you it works with wireless
cards.  Does ifconfig show your interface?

On Fri, Mar 15, 2019, 4:51 PM Mike . <[email protected]> wrote:

> this is my 3rd message that will prob be ignored again. anyway, does nmap
> just not work on wireless cards? went down to my local lib, plugged in and
> got this after firing it up
>
> Starting Nmap 7.70 ( https://nmap.org ) at 2019-03-15 15:49 Central
> Daylight Tim
> e
> Initiating Ping Scan at 15:49
> dnet: Failed to open device eth0
> QUITTING!
>
> odd thing though. i am not using ETH0! that is my ethernet that is
> DISABLED! so does it just not support my standard Intel  WIRELESS card?
> wlan? wont even see it listed with --iflist. what gives
> _______________________________________________
> Sent through the dev mailing list
> https://nmap.org/mailman/listinfo/dev
> Archived at http://seclists.org/nmap-dev/

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/