Issue with nmap-4.75 on Solaris 10 and IPv6

Hello

I am trying to use nmap-4.75 on Solaris 10, I used the following to
configure nmap:

./configure --prefix /opt/nmap --without-zenmap --enable-ipv6

then I run make and make install.

The Solaris 10 server I am running the application on is IPv6 enabled,
however, when I issue the following command:

nmap -6 ::1

I get the following error:

I am afraid IPv6 is not available because your host doesn't support it or
you chose to compile Nmap w/o IPv6 support.
QUITTING!

Has anyone else seen this issue?  I searched Google and the nmap archives.

John
-- 
===================================
John Jason Brzozowski
===================================

_______________________________________________
Sent through the nmap-dev mailing list
http://cgi.insecure.org/mailman/listinfo/nmap-dev
Archived at http://SecLists.Org