Re: ERROR: Invalid command: debug
Matt Darfeuille <[email protected]> Tue, 23 Aug 2022 14:35:32 +0200
| Newsgroups | gmane.comp.security.shorewall |
|---|---|
| Message-ID | <[email protected]> |
On 8/22/2022 12:09 PM, Vieri Di Paola wrote:
> Hi,
>
> I hit this error message on a shorewall check:
>
> ERROR: Invalid command: debug
>
> This happened only after I added some more lines in the routes file.
> They all had the same syntax;:
>
> $PROVIDER $DEST_IP_ADDR - ${IF_LAN}.111
>
> What does "debug" refer to?
>
As far as I can tell, the doc does not talk about 'debug' [1].
[1] https://shorewall.org/manpages/shorewall-routes.html
--
Matt Darfeuille <[email protected]>
Community: https://sourceforge.net/p/shorewall/mailman/message/37107049/
SPC: https://sourceforge.net/p/shorewall/mailman/message/36596609/
Homepage: https://shorewall.org