Re: enabling DMG and XAR support
Mark Allan <[email protected]>
| Newsgroups | gmane.comp.security.virus.clamav.devel |
|---|---|
| Message-ID | <[email protected]> |
Just out of interest, did you test to see if it *actually* worked?
My configure output shows that dmg and xar are supported, but it doesn't actually detect the Eicar test file within a disk image.
configure: Summary of engine detection features
autoit_ea06 : yes
bzip2 : ok
zlib : /usr
unrar : yes
dmg and xar : yes, from /usr
When I create a new disk image, copy the Eicar test file in, and scan the dmg, it shows up as being clean.
> clamscan test.dmg
> test.dmg: OK
>
> ----------- SCAN SUMMARY -----------
> Known viruses: 3259558
> Engine version: 0.98.1
> Scanned directories: 0
> Scanned files: 1
> Infected files: 0
> Data scanned: 10.07 MB
> Data read: 10.02 MB (ratio 1.01:1)
> Time: 4.845 sec (0 m 4 s)
Does this work as expected for anyone else?
Mark
On 10 Feb 2014, at 23:38, Rafael Ferreira <[email protected]> wrote:
> That worked, thanks!
>
> On February 10, 2014 at 4:29:41 PM, Steven Morgan ([email protected]) wrote:
>
> Rafael,
>
> Probably all you need to do install libxml&libxml2-dev, which is used by
> dmg and xar, then do your configure/make.
>
> Steve
>
>
> On Mon, Feb 10, 2014 at 6:05 PM, Rafael Ferreira <[email protected]>wrote:
>
>>
>> Folks,
>>
>> I'm compiling clamav 0.98.1 on Linux (Ubuntu 12.04 LTS) and I'm not
>> getting the new super awesome DMG and XAR file support:
>>
>> configure: Summary of detected features follows
>> OS : linux-gnu
>> pthreads : yes (-lpthread)
>> configure: Summary of miscellaneous features
>> check : no (auto)
>> fanotify : yes
>> fdpassing : 1
>> IPv6 : yes
>> configure: Summary of optional tools
>> clamdtop : (auto)
>> milter : yes (disabled)
>> configure: Summary of engine performance features)
>> release mode: yes
>> jit : yes (auto)
>> mempool : yes
>> configure: Summary of engine detection features
>> autoit_ea06 : yes
>> bzip2 : ok
>> zlib : /usr
>> unrar : yes
>> dmg and xar : no
>>
>> Am I missing a configure flag or third party library?
>>
>> Thanks in advance,
>>
>> - Rafael
>>
>> ----
>> scanii.com - the web friendly malware scanner!
>> _______________________________________________
>> http://lurker.clamav.net/list/clamav-devel.html
>> Please submit your patches to our Bugzilla: http://bugs.clamav.net
> _______________________________________________
> http://lurker.clamav.net/list/clamav-devel.html
> Please submit your patches to our Bugzilla: http://bugs.clamav.net
> _______________________________________________
> http://lurker.clamav.net/list/clamav-devel.html
> Please submit your patches to our Bugzilla: http://bugs.clamav.net
_______________________________________________
http://lurker.clamav.net/list/clamav-devel.html
Please submit your patches to our Bugzilla: http://bugs.clamav.net