RE: Cannot get PIX 501 version 6.3 (1) to work with NAT
"Keith Pachulski" <[email protected]>
| Newsgroups | gmane.comp.security.vpn |
|---|---|
| Message-ID | <[email protected]> |
not sure how this question applies to this list but anyhow -- did you use the global statement to define the interface to translate to or a pool to translate too? global (outside) 1 interface - example -----Original Message----- From: Anna Secka Saine [mailto:[email protected]] Sent: Thursday, October 09, 2003 2:06 PM To: [email protected] Subject: [VPN] Cannot get PIX 501 version 6.3 (1) to work with NAT I seem to have trouble with NAT on the above version. The PIX can ping but the machines inside cannot ping or browse. I did have nat enabled, i.e. nat (inside) 1 0 0. The same configurations works on version 6.2 (2). Any ideas. Thanks. _______________________________________________ VPN mailing list [email protected] http://lists.shmoo.com/mailman/listinfo/vpn