Re: Ciscon 3060 and Linksys or Netgear or Dlink or.....
"Dana J. Dawson" <[email protected]>
| Newsgroups | gmane.comp.security.vpn |
|---|---|
| Organization | Qwest Communications |
| Message-ID | <[email protected]> |
We've done some testing with the Linksys and a Cisco VPN 3015 and it seemed to work fine. The key with setting up any VPN is to match the various config parameters on each device, which is harder than it might seem because different vendors have different default values that may or may not appear in the config, and they sometimes use different terminology for some things. It's also important to have the latest firmware/software, especially in the smaller boxes, since VPN support is still a new thing for some of them and it can change often. HTH Dana -- Dana J. Dawson [email protected] Sr. Staff Engineer CCIE #1937 Qwest Communications (612) 664-3364 600 Stinson Blvd., Suite 1S (612) 664-4778 (FAX) Minneapolis MN 55413-2620 "Hard is where the money is." Walt Reynolds wrote: >Howdy, > >I am wondering if anyone out there has set up a tunnel between a cisco >concentrator and one of the smaller hardware VPN boxes (IPSec). A few >examples are as follows: > >Linksys BEFSX41 >DLink DI-804HV >Netopia R910 >NetGear FVS318 > >Any informational feedback would be appreciated. Both pros and cons. > >-- Walt Reynolds > University of Michigan >_______________________________________________ >VPN mailing list >[email protected] >http://lists.shmoo.com/mailman/listinfo/vpn > > >