Re: Recommendations

"Dana J. Dawson" <[email protected]>
Newsgroups gmane.comp.security.vpn
Organization Qwest Communications, Inc.
Message-ID <[email protected]>
One issue I've had with Netscreen firewalls in the past is that I've
never managed to get them to support IPSec pass-thru for generic IPSec
clients through the Netscreen in router mode with PAT (i.e. not using
NAT-Traversal or any other type of TCP/UDP encapsulation of the IPSec
traffic). Is this a known limitation of the Netscreen, or is there a
trick I haven't found? I haven't tried the latest software, so maybe
this is no longer an issue - the last version I've tried is 4.0.3r3.0
in a 5XP.

Dana

Travis Watson wrote:

Paul,

You've already received some good recommendations and I don't mean to poor it
on, but you may want to look at m0n0wall as well for the smaller
site--particularly if management is cheap ( http://m0n0.ch/wall/ ). It's
pretty cool stuff and the price is right.

Having said that, I usually lean toward Netscreen. They are very reasonable
in price, solid, and easy to manage. The only caustion I would give you is
that the 5-series has the 10 user and "unlimited" option for VPN. Ten nodes
through a tunnel can happen pretty quickly and the unlimited option just
about doubles the price. The 10 user limitation is for VPN only, however,
not general connectivity.

Good luck.

--Travis

On Thursday 08 April 2004 08:39 pm, Paul R. Yaskowski wrote:

I'm looking to setup a site-to-site VPN the replace a leased line used
solely for AS/400 access. I have a couple questions as to what I should
get.

The main office consists of about 25 users with static SDSL. The remote
office is about 5 users with dynamic ADSL.

I've looked at the PIX-501, but I've always been a little scared of
per-user licensing. If I purchased a 10-user PIX-501, and set it behind the
SDSL at the main office, it would only allow 10 users to get Internet
access?

No matter what product I choose, would a site-to-site VPN work with a
static address on one side and a dynamic on the other?

Would any PIX handle PPPoE with a dynamically assigned IP?

The company is cost-conscious, and I've looked at the PIX-506E, without the
per-user licensing, but it is 50% more.

Any comments or suggestions as to which products I should look at would be
a great boon to me. I prefer Cisco products, because I am familiar with
their interface, but am flexible.

I would appreciate any help with this, I had Cisco certs back in the
hey-day, but I worked with them so rarely that I let the certs expire.

Paul

_______________________________________________
VPN mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/vpn

_______________________________________________
VPN mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/vpn

_______________________________________________
VPN mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/vpn
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.