RE: Pix 515E VPN tunnel Via Cisco Client 4.0 thru a Nattted home DSL router
"Hart, Kevin" <[email protected]> Mon, 13 Sep 2004 10:27:05 -0400
| Newsgroups | gmane.comp.security.vpn |
|---|---|
| Message-ID | <[email protected]> |
If I understand this correct...the VPN client behind a PAT device cannot connect to the PIX 515 firewall. Isakmp NAT traversal on the PIX will allow multiple clients behind a PAT device to connect, but is not related to your problem. It would seem that you need to enable IPSEC passthrough on your home network device. Do you have a router behind the DSL modem. If not, is there any way to enable this on the DSL modem. The other possibility is that your ISP is blocking IPSEC. Are you logging to Syslog on the PIX? This will give you good information as to what is happening on that end. Kevin -----Original Message----- From: Marc Stavale [mailto:[email protected]] Sent: Friday, September 10, 2004 5:46 PM To: [email protected] Subject: [VPN] Pix 515E VPN tunnel Via Cisco Client 4.0 thru a Nattted home DSL router Scenario: I have a Pix 515E configured to access a VPN tunnel. If I dial into the internet thru AT&T and get an IP of 206.x.x.x (internet routable), address and try to negotiate a tunnel using the Cisco VPN Client I can do so no problems. However, if I try to do one from my 'house' which is behind my DSL modem and thus has a natted address (IE: my modem outside is routable but my inside address on my computer is a 192.168.0.x address's), my tunnel fails. Here is a copy of my Pix config and I do have the 'isakmp nat-traversal' command in it but it still fails. I havn't configured my inside conduits yet as just want to get the tunnel working first. Any ideas? Building configuration... : Saved : PIX Version 6.3(3)133 interface ethernet0 100full interface ethernet1 100full interface ethernet2 auto shutdown nameif ethernet0 outside security0 nameif ethernet1 inside security100 nameif ethernet2 intf2 security4 enable password fOtLfvYl90/VEkOk encrypted passwd 2KFQnbNIdI.2KYOU encrypted hostname denvervpn fixup protocol dns maximum-length 512 fixup protocol ftp 21 fixup protocol h323 h225 1720 fixup protocol h323 ras 1718-1719 fixup protocol http 80 fixup protocol rsh 514 fixup protocol rtsp 554 fixup protocol sip 5060 fixup protocol sip udp 5060 fixup protocol skinny 2000 fixup protocol smtp 25 fixup protocol sqlnet 1521 fixup protocol tftp 69 names access-list 102 permit ip 192.168.0.0 255.255.252.0 192.168.113.0 255.255.255.0 pager lines 24 mtu outside 1500 mtu inside 1500 mtu intf2 1500 ip address outside 12.45.111.234 255.255.255.248 ip address inside 192.168.8.17 255.255.255.248 no ip address intf2 ip audit info action alarm ip audit attack action alarm ip local pool vpnpool 192.168.113.1-192.168.113.254 pdm history enable arp timeout 14400 nat (inside) 0 access-list 102 conduit permit icmp any any route outside 0.0.0.0 0.0.0.0 12.45.111.225 1 timeout xlate 3:00:00 timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00 timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00 timeout uauth 0:05:00 absolute aaa-server TACACS+ protocol tacacs+ aaa-server RADIUS protocol radius aaa-server LOCAL protocol local no snmp-server location no snmp-server contact snmp-server community public no snmp-server enable traps floodguard enable sysopt connection permit-ipsec crypto ipsec transform-set myset esp-des esp-md5-hmac crypto dynamic-map dynmap 10 set transform-set myset crypto map mymap 10 ipsec-isakmp dynamic dynmap crypto map mymap client configuration address initiate crypto map mymap client configuration address respond crypto map mymap interface outside crypto map map1 10 ipsec-isakmp dynamic map2 isakmp enable outside isakmp identity address isakmp client configuration address-pool local vpnpool outside isakmp nat-traversal 10 isakmp policy 10 authentication pre-share isakmp policy 10 encryption des isakmp policy 10 hash md5 isakmp policy 10 group 2 isakmp policy 10 lifetime 86400 vpngroup base1 address-pool vpnpool vpngroup base1 dns-server 192.168.0.125 vpngroup base1 wins-server 192.168.0.126 vpngroup base1 default-domain amc.local vpngroup base1 idle-time 1800 vpngroup base1 password ******** vpngroup base2 address-pool vpnpool vpngroup base2 dns-server 192.168.0.125 vpngroup base2 wins-server 192.168.0.126 vpngroup base2 default-domain amc.local vpngroup base2 split-tunnel 102 vpngroup base2 idle-time 1800 vpngroup base2 password ******** telnet timeout 5 ssh timeout 60 console timeout 0 terminal width 80 Cryptochecksum:5ddd4c6f87bb9677e21fdff9262b50ac : end [OK] Marc Stavale Network Engineer Airmethods 7211 S. Peoria St. Englewood Co. 80112 303-792-7491