Re: VPN layout question
Walter Reynolds <[email protected]> Wed, 27 Oct 2004 10:37:41 -0400 (EDT)
| Newsgroups | gmane.comp.security.vpn |
|---|---|
| Message-ID | <[email protected]> |
I am not sure where these consultants are from, but one of the main points of a VPN is that you do not need all those costly point-to-point links. Your scenario should work just fine. -- Walter Reynolds University of Michigan On Tue, 26 Oct 2004, Chris Dahms wrote: > Hi, > > I work for a small doctors office that has three locations across long > island and we are looking to overhaul our network connection in > conjunction with upgrading our practice management software. Currently > we have a 'vpn' of sorts setup by point to point frame relay from two of > the offices to the main office. The hardware 8+ years old and failing, > so we need to replace everything. > > The network needs to provide secure communication between all three > offices. The practice management software we uses resides on one server > at our main location, and needs to be able to securely communicate with > the other two offices. > > My question is with regard to the network toplogy. I was under the > impression we could get a T1 to each site, buy cisco 2600 series routers > for each office with a VPN module card, and set it up so that office 1 > was on say 192.168.1.x, office 2 on 192.168.3.x and office 3 on > 192.168.4.x and then when office 1 wanted to communicate with office 2, > the packets from office 1 would be encrypted and routed by the vpn > module over to the router at office 2 and sent to the appropriate > machine. Then as a backup we could have dsl at each location hooked into > the router, and if the t1 when down it would fail over to the dsl. > > The network consultants we contract with are recommending point to point > t1's from each smaller office to the main office with the network > server, and then having each office have a seperate t1 for an internet > connection, in addition to the dsl failover. When I asked about the > design I had in mind, they replied it was unsecure/unreliable but failed > to explain why. > > My question is: is the network toplogy I have in mind feasible/reliable, > or do we need point to point internet connections between the offices to > establish the vpn ? > > thanks, > chris > _______________________________________________ > VPN mailing list > [email protected] > http://lists.shmoo.com/mailman/listinfo/vpn > > >