Re: Best way to setup VPN for clients?

The easiest and faster would be to configure cisco vpn clients. You
can download the software from the following link:

http://www.cisco.com/cgi-bin/tablebuild.pl/vpnclient-3des

and redistribute it to your colleges.

And here are the steps to configure cvpn client on the pix:

Define a pool of address to assign the clients

ip local pool poolclient 10.1.2.1-10.1.2.254

Configure Phase 1 and Phase 2

PHASE 1

isakmp identity address
isakmp policy 10 authentication pre-share
isakmp policy 10 encryption des
isakmp policy 10 hash md5
isakmp policy 10 group 2
isakmp policy 10 lifetime 86400
isakmp enable outside

isakmp nat-traversal 20

PHASE 2

sysopt connection permit-ipsec
crypto ipsec transform-set myset esp-des esp-md5-hmac 
crypto dynamic-map dynmap 10 set transform-set myset
crypto map mymap 10 ipsec-isakmp dynamic dynmap
crypto map mymap interface outside

VPN CLIENT

vpngroup vpn3000 address-pool poolclient
vpngroup vpn3000 dns-server <ip address>
vpngroup vpn3000 wins-server <ip address>
vpngroup vpn3000 split-tunnel split
vpngroup vpn3000 idle-time 1800
vpngroup vpn3000 password <type a password>

access-list split  permit ip <internal network> 255.255.255.0
10.1.2.0 255.255.255.0
access-list nonat permit ip <internal network> 255.255.255.0 10.1.2.0
255.255.255.0
nat (inside) 0 access-list nonat

Hope this helps!

Aida Lumbreras