Re: Internet access through vpn (gateway-to-gateway)

My only experience with these Netgear routers has been bad.

You can try a Universal Tunnel, using subnet 0.0.0.0 with mask 0.0.0.0 


Office 1:	192.168.1.0/24
Office 2:	192.168.2.0/24

Office 1 tunnel definition from 192.168.1.0 -> 0.0.0.0
Office 2 tunnel definition from 0.0.0.0 -> 192.168.1.0

Thanks,
~Todd

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf
Of George Jammal
Sent: Tuesday, January 23, 2007 11:21 AM
To: [email protected]
Subject: [VPN] Internet access through vpn (gateway-to-gateway)

Hello everyone,

I have 2 offices each with its own router (Netgear FVS318v3) and
internet access with a different ISP. I'm trying to get computers in
office1 to access the internet (at least http) through  the router  in
office2. In other words, if a computer in office1 attempts to go to a
website using a browser I want the request to go through the vpn tunnel
to the router in office2 and to use the ISP of router2.

I haven't seen anything in the Netgear documentation that describes this
scenario. I would like to know if I can configure Win2k in office1
and/or the routers to accomplish this (preferably without involving any
computer in office2). Is this even possible? If not, what is the minimum
software or hardware I need to accomplish this?

On their own, the routers are working fine and a vpn tunnel is
established between the 2 routers. I can ping computers in office2 from
a computer in office1 and windows networking is working between the 2
offices (i.e. I can see computers in the other office in 'My Network
Places' and copy files back and forth).

I appreciate and welcome any suggestions even if not specific to the
FVS318.

George


_______________________________________________
VPN mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/vpn

## Scanned by Delphi Technology, Inc. ##