Recommendations on compression settings w/ Zebedee and UltraVNC?

I've noticed that when using Zebedee and UltraVNC with default settings,
over a T1, that the response if very jagged and slow.  I'm assuming some of
this is due to both Zebedee and UltraVNC using compression, and also the bit
depth on each side of the connection?

I have tried changing the compression settings in UltraVNC, but it seemed it
made no difference.  I'm open to suggestions.  ;) 

On another note, I had some problems with 2.5.1 clients accessing 2.5.2
Zebedee servers (as Neil's readme said I would) but everything worked fine
after upgrading everything to 2.5.2.  A new version of UltraVNC is out too,
it looks really nice.

Mark G. Spencer
Computer Forensics Examiner
EvidentData, Inc.
Phone: 909.948.7714
Direct Fax: 508.256.0463
Office Fax: 909.948.4365
Web: http://www.evidentdata.com   



-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf