Re: BPCS and using the Sys Req Attn key.

ehhh ... I'm a little unclear on where that bpcs model comes from but. . .

W'ere on 7.2 (both dev & prod boxes) and our (dspsysval) qmodel is E4A.

John

<snip>
Oh my, that is old.
And an 810 tops out at IBM i 6.1.
http://www-01.ibm.com/support/docview.wss?uid=ssm1platformibmi
But with your ERP that old I wouldn't go past V5R4 since anything past 
that will require some updates from Infor and since you're not paying 
maintenance you best just plan on purchasing it from scratch again.  Might 

be cheaper than back maintenance.  They're really not in the mood to shaft 

those of us who religiously pay maintenance and cut those who don't a 
break.
And, if you're not paying maintenance to IBM either I'd stay at the OS 
you're on since any upgrade will require new software keys from IBM.

You might want to check your DR plan.  Because you are in for a really 
rude surprise if you think you are going to be able to restore that and 
run it on a different machine for anything less than a good six figures. 
Not counting hardware...
</snip?
<br />
The information in this email is confidential and may be legally privileged.
It is intended solely for the addressee. Access to this email by anyone else is
unauthorized. If you are not the intended recipient, any disclosure, copying,
distribution or any action taken or omitted to be taken in reliance on it, is
prohibited and may be unlawful.
-- 
This is the BPCS ERP System (BPCS-L) mailing list
To post a message email: BPCS-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/bpcs-l
or email: BPCS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/bpcs-l.