RE: How to indent a block of code

> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> 
> Using Code/400 I want to indent a block of code.  So I looked 
> at the keys 
> help.  Looked like F8 is the trick.  However after 
> highlighting a block of 
> code, through various methods, and hitting F8 all's it did 
> was move my 
> cursor down a page.  I kept trying this until it blew code 

If you are using SEU compatibility for the editor you can still use the "RR#" code in the line number section to move that block of code over # positions to the right. 

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo.cgi/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l