Re: How to indent a block of code
"Simon Coulter" <shc-Q/[email protected]>
| Newsgroups | gmane.comp.systems.as400.code |
|---|---|
| Message-ID | <[email protected]> |
Hello Rob,
You wrote:
>Alt-A brought down the Actions menu.
I think the Alt key behaviour depends on whether you have advanced marking
enabled but it's been too long since I last used CODE and I'm not going to
boot to Windows to verify. Search for marking options and key behaviour.
Regards,
Simon Coulter.
--------------------------------------------------------------------
FlyByNight Software AS/400 Technical Specialists
http://www.flybynight.com.au/
Phone: +61 3 9419 0175 Mobile: +61 0411 091 400 /"\
Fax: +61 3 9419 0175 mailto: shc-Q/[email protected] \ /
X
ASCII Ribbon campaign against HTML E-Mail / \
--------------------------------------------------------------------
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo.cgi/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.
NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l