Setting up CODE as the default editor
"Edwards, Douglas" <Douglas.Edwards-dmCY9Rel/[email protected]>
| Newsgroups | gmane.comp.systems.as400.code |
|---|---|
| Message-ID | <[email protected]> |
Has anyone on version 4 of WDSC successfully changed the default editor so it is CODE rather than LPEX? If so, how? I went thru the steps I thought should work, but LPEX is still the default editor. I am current I believe (at Service Pack 4). Thanks Doug Edwards - Fidelity IFS Douglas.Edwards-dmCY9Rel/[email protected] Phone (407) 875-1818 ext. 141 Fax (407) 875-1181 _______________________________________________ This is the CODE/400 Discussion & Support (CODE400-L) mailing list To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/code400-l or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/code400-l. NOTE: WDSc for iSeries disucssion has it's own mailing list. Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l