Re: repost - STRCODE workstation security error?

Hak,

Thanks for your reply.

iseries V5R1M0
windows 98se
wdsc v4

all service packs and ptfs up to date.

what I meant by yesterday and today - yesterday (actually a week ago) at
home via cable modem and vpn, today (again a week ago), at the office on
novell network.

strCode connected and ran just fine from home, didn't from office.

could you elaborate on what you mean by 'power user group'?  I pretty much
have the run of my pc (I can install anything I want, see/change/configure
anything on it - the only thing I can't change is my network security
settings.

does the iseries have to have some sort of admin rights to the pc?

Thanks again,

Rick

-------original message----------
Rick:
      you didn't mention which iSeries release/version, Windows OS, and
CODE release/version/service pack you were on.
I am not clear on what were in  'this morning' and 'yesterday'? Were you
still working from home/VPN when it was not working?

1. You need at least be in the 'power user group' to start CODE on PC.
2. If you are switching from one network to another, make sure that the
PC's network configuration be reset.
3. Please make sure that a unique *CURLIB is defined in your iSeries
sign-on user profile.
4. STRCODE default port is 4200. Please try
      STRCODE SERVER(BAIRDR) RMTLOCNAME('mypc.ip.address') CMNTYPE(*TCPIP)
PORT(4200)

Best regards,
    Hak


_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l