RE: CL prompt in STRCODE session hangs
"Don Freeman" <[email protected]>
| Newsgroups | gmane.comp.systems.as400.code |
|---|---|
| Message-ID | <3CFC768946A2EB4983B2FD53F3EBCEE3310F2C@exch-int01.norcalwaste.com> |
> -----Original Message----- > From: Vern Hamberg [mailto:vhamberg-Ebbh53c6wcYkzXN11fiE55igCaZBIYHkAL8bYrjMMd8@public.gmane.org] > > Problem is, when I STRCODE, then open CODEEDIT, then open a > CLLE member and > prompt a command (GUI prompting is off), both CODE and the > PC5250 session hang. > I'm not running the same version as you but whenever I do the above my session appears to hang but in actuality the server session is waiting for input (the CL prompt) and once the enter key is hit the server screen goes back to its waiting state and my CODE session is usable again. _______________________________________________ This is the CODE/400 Discussion & Support (CODE400-L) mailing list To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/code400-l or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/code400-l. NOTE: WDSc for iSeries disucssion has it's own mailing list. Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l