RE: How can I "wow" developers with CODE in WDSc 5.0?

Jon,

The new UI layer that was written runs without a single problem on Linux !
(just take a look at Eclipse).

It is again IBM (while investing tons of dollars in Linux ?) that messed it
up with RSE and the iSeries tools... they don't run on Linux.

Kind regards,
Paul

-----Original Message-----
From: code400-l-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] [mailto:[email protected]]
On Behalf Of Jon Paris
Sent: woensdag 23 juli 2003 0:25
To: code400-l-Zwy7GipZuJhWk0Htik3J/[email protected]
Subject: How can I "wow" developers with CODE in WDSc 5.0?


 >> Now I imagine if Bill Gates had any interest in writing a front-end for
IBM's WebSphere using core win32 API's.... HA!

Actually I believe that IBM have done just this.  It is one of the reasons
why all of the additional features of WDSc etc. are not yet available on
Linux etc.  If they used swing, it would run on Linux no problem, but it
doesn't - they wrote a new layer of JNI routines to provide the UI.

Imagine how slow it might be if they were using swing!

Jon Paris
Partner400
www.Partner400.com



_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l