Server already running

I am trying to start CODE on the iSeries (STRCODE), but every time it
says that the server I would like to open is already started. I can run
some commands in CODE, but I can't see anything on my 5250 session. I
tried running EDTLIBL from the editor, but I received an error. I called
a program from the editor and it ran without any errors. I'm guessing I
didn't properly end my STRCODE connection yesterday, but I'm not sure. I
didn't see any jobs in WRKACTJOB that looked suspicious. Does anyone
have any idea what is going on?

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l