RE: Password not accepted since last changed
"Johnson, Duane" <djohnson-8/[email protected]>
| Newsgroups | gmane.comp.systems.as400.code |
|---|---|
| Message-ID | <[email protected]> |
> From: Mark Keller [SMTP:mkeller-L/[email protected]] > did you perhaps put the password into your strcode command? I am guessing > that could be your problem? > No, the password is not in the strcode command, simply because I don't use STRCODE. I'm on V5R2, which does not require it. > From: Wills, Mike N. (TC) [mailto:[email protected]] > It is in the communication daemon down by your clock in Windows > [Johnson, Duane] I suppose it's possible that it's contained in the communication daemon, but if so, I can't get there to change it, nor could I have gotten there to put it there in the first place. When I try to bring up "Properties" I get the busy signal (hourglass) for a few seconds then nothing more. It has been that way ever since I've had this computer. I'm pretty sure that it was either a macro that I modified or a command line change, but I don't remember which. > _______________________________________________ This is the CODE/400 Discussion & Support (CODE400-L) mailing list To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/code400-l or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/code400-l. NOTE: WDSc for iSeries disucssion has it's own mailing list. Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l