Unable to reopen a file for Edit

I was editing a file this morning with Code and the power went out while the
file was open.  Now that I am back on, I am unable to open the file for edit
through Code 400 or even regular old SEU.  From the messages I see, the file
is still open because the server session is still active.  Is it a good idea
to locate the server session and end it to release the file?  If I do that,
will I need to do anything else to clean up?



Richard L. Weber  |  Senior Systems Analyst, TOYS 'Я' US International  |
973.617.3497  |  [email protected] <mailto:[email protected]> 


_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l