Re: Verify Multiple Times - Source becomes read only

Hello:

Here is more information on my problem.

I have a source member open for editing.  I did a verify and had errors.  I 
corrected the errors and did verify again.  The verify reported 'Verify 
program action completed with informational and/or warning messages'.  In 
other words, it verified ok.

The windows that pop during verify process seemed to have an extra 'flash' 
and then I notice the save button for the source I just verified changes to 
dimmed out.

After further investigation, I think what is happening is that the file 
properties are somehow getting blown away by the verify process.

When I checked the file properties, the description for the source had 
changed to 'GLOBAL.LOCKLOCALFILES', the record length was set to zero and 
the source type was blank.

The only work around I've figured is to reload from scratch.

When I try to save under a different name, I have problems where the 
sequence number and date fields are not mapping to the file source file 
properly.

This 'read only' problem is intermittent, it only happens once in a while.

Any ideas?

John

_________________________________________________________________
Page a contact’s mobile phone with  MSN Messenger 6.0. Download it now FREE! 
   http://msnmessenger-download.com

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l