Debugger Settings

I am having a problem with changing the Update Production Files parm on 
the debug command.  I have read that this should be able to be changed 
when you select the AS/400 tab in the Load Program dialog box.  There is a 
button labeled Debugger Settings that supposedly has this parm on it, but 
this button is "grayed" out and can not be used.  Anyone out there have a 
solution?

Thanks,

Dan Bartz
Sr. Business Programmer/Analyst
Mead Westvaco Consumer and Office Products
Phone: (607) 563-9411 ext. 2421

________________________________________________________________________
This email has been scanned for all viruses by the MessageLabs SkyScan
service._______________________________________________________________

This electronic message contains information from MeadWestvaco
Corporation or subsidiary companies, which may be confidential,
privileged or otherwise protected from disclosure.  The
information is intended to be used solely by the recipient(s)
named.  If you are not an intended recipient, be aware that
any review, disclosure, copying, distribution or use of this
transmission or its contents is prohibited.  If you have
received this transmission in error, please notify MeadWestvaco
immediately at postmaster-acgFIG3GRJw0wsQ+md68IeG/[email protected]
_______________________________________________________________________
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l