Slow Response

This is more of a bother than a problem.  I've got the following PDM user
options set up to start the CODE editor or designer.

call qdevtools/evfcfdbk parm('37' 'Y' 'OS400' '<LOCAL> CODEEDIT
"<>&L/&F(&N)" ')
call qdevtools/evfcfdbk parm('37' 'Y' 'OS400' '<LOCAL> CODEDSU
"<>&L/&F(&N)" ')

The thing is that some days when I type the option and hit ENTER they pop
right up.  Other days I might wait anywhere up to a minute for the member
to load.  Once it starts up everything is responsive.  If I start the
program on the PC and then open the member the speed is good.  Could
something stand to be tweaked on the AS/400 side?  Our system is a 720 and
doesn't seem to be all that busy at the times that I experience this.  We
are at V5R1 on the AS/400 with fairly recent PTF's.  WDSC is 5.1.  Thanks.

Dave Parnin
Nishikawa Standard Company
Topeka, IN  46571
[email protected]

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l