Mouse wheel?

Hi group,

I yesterday installed WDSCi 5.1.0.3 on a Dell Optiplex with a wheel-less 
mouse.

When attaching a wheel mouse today, I noticed that the scrolling works in 
all programs except CODE/400, which was the program where I especially 
wanted to be able to scroll.

The archives give several solutions - which I tried but didn't work - such 
as using the newest drivers from M$ etc.  I even swapped the 'Dell by 
Microsoft' wheel mouse with an optical wheelmouse 'Microsoft by 
Microsoft', but to no avail.

Has anybody been able to find a solution for this?  Could it be because at 
installation time there was no wheel, some obscure switch was set to block 
wheel scrolling in CODE?

For what it's worth, in WDSCi the scrolling works, but this being a 1 GHz 
pc with only 256 MB Ram, that is not an option.

Thanks in advance.

Peter Colpaert
Application Developer
Massive - Kontich - Belgium
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l