RE: WDSC V5.1.2.3 & Code/400 Changes

Hi David,

CODE uses the member type to set the source type (you don't mention what
your full member name/type was).
It also uses Associations to determine source type, when member type is
absent, see Options->Associations->Name Patterns

Hope this helps!

Violaine Batthish
WebSphere Development Studio Client, IBM Toronto Lab




code400-l-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] wrote on 12/15/2004 07:29:38 PM:

> Nevermind :)
>
> For some reason when I launched the SQLRPG source from WDSC to Coed/400
> it did not set the source code type properly.  Once I manually changed
> it the menus were restored to a familiar state :)
>
> If there a way to get Code/400 and WDSC to set the source type
> automatically?
>
> Thanks,
> David
>

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsc-l