Long Time For Building Source File List.

One of the major frustration factors I have with Code400/Designer is the
amount of time it takes to build the source file list when I first start
my connection in the morning. Some days it takes 2, 3, or 4 minutes to
build this list to enable me to drill down to the source member I want.
As I write this I am also waiting for the a DDS to load into Designer.
I've been waiting for  2m 35s. This is my first 'load' of the day, and I
have noticed that subsequent opens are much quicker.

Is it something in the configuration or do I just live with it and
eventually go back to PDM?

Any advice is welcome.

Thanks.

Mike Pantzopoulos




*********************************************************************************************************
This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you are not the intended recipient, any use, disclosure or copying of this message is unauthorised. If you have received this message in error, please reply using the sender's email address. 

This footnote confirms that this email message has been scanned for computer viruses. EIG-Ansvar Limited does not accept liability for any loss or damage, whether caused by our own negligence or not, that results from a computer virus or defect in the transmission of this email or any attached file. 
EIG-Ansvar Limited - Australia (A.B.N. 21 007 216 506)
Email : [email protected]

Eig-Ansvar Limited - New Zealand
Email : [email protected]

*********************************************************************************************************

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries discussion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsci-l