Host session not ending

I'm using the IBM distributed debugger from Code. 

 

If I recall correctly, in the past I could run the STRCODE command from
an interactive session, which results in a series of three beeps of
ascending pitch and a screen locked up and waiting for the PC side to do
something.

 

Then I go do my debugging on the PC side, and my interactive application
shows up in the emulation session, I do my stuff there.

 

When my program ends or I halt it from the PC side, I thought the Host
session was supposed to end and return my emulation session to a command
line, with a series of three beeps of descending pitch.  

 

This isn't happening lately.  Everything works OK until I am done
debugging, and I get the PC message that the debug session has
completed, but the emulation session is still locked up, so I have to
unceremoniously kill it.  Then I can't debug again, because the default
host is still active.  

 

I did, however, accidentally discover a way to end it, which is to
attempt to create a new print file in Code Designer, upon which time it
gives me an "unable to send data to host server" message, and then
finally gives me the three beeps in descending pitch, at which time I
can then run STRCODE again and start the whole ball rolling again.  

 

I suppose I could leave an emulation session dedicated to debugging all
day and just never kill it, but I thought it was supposed to close at
the end of the debug session, returning my emulation session to me.  Is
there another way to end the host session normally ? 

 

Thanks

 

Greg Fleming

Programmer/Analyst

Everglades Direct, Inc.

 

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries discussion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsci-l