CODE Designer NOT loading screens

Good afternoon,

 

I've been using WDSC 5.1.2 and CODE400 Designer.  Recently, we upgraded to
WDSC 7.0.  Ever since the install CODE Designer will not load any screens.
The little pop up window with the timer appears and it says that it's
loading the source, but it never loads.

 

I found these instructions in a thread on midrange.com, but I changed the
'codeedit' portion to 'codedsu'.  Still no luck.

 

"First, make sure the PC Organizer is running. (STRPCO).
Then use the following PDM option:
STRPCCMD PCCMD('codeedit <OS400>&L/&F(&N)') PAUSE(*NO)"

 

Anyone ideas are appreciated.


Thanks,


Frank

 

 

_______________________________________________
This is the CODE/400 Discussion &amp; Support (CODE400-L) mailing list
To post a message email: CODE400-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries discussion has it's own mailing list.
Information can be found at http://lists.midrange.com/cgi-bin/listinfo/wdsci-l