PO vs MO

Hello All,   A while back there was a discussion going on about outside
processing and inside processing.  At the time, I didn't think it pertained
to me, but as always, it has come up.  We have always had outside processing
for assemblies/weldments, but now we are using outside processing as well as
some inside processing to manufacture a single component.  For instance,
when we cut parts from stainless steel, we send the metal out to be laser
cut into shape.  Then we get the part back and send it through the press
brake at our facility to put a bend.  Obviously we have to pay for the laser
cut, but dont want to execute a purchase receipt because we have a work
order for the bending that will also close out and add a qty to stock.  Thus
giving a double receipt.  How do you guys do this?  I am almost sure this
was discussed a bit a few weeks ago, but I seem to lost the conversation
while purging my outlook.  Any help is appreciated.
Todd Ivy

TYMCO, Inc.
225 E. Industrial Blvd
Waco, Tx 76705

T:(254) 799-5546  Ext:389
F:(254) 799-2722

www.tymco.com









_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.