Another backup question
"Mark Murphy/STAR BASE Consulting Inc." <[email protected]>
| Newsgroups | gmane.comp.systems.as400.mapics |
|---|---|
| Message-ID | <OF5D29822E.6E9C13B5-ON8525770A.004A5E93-8525770A.004ACA5C@starbaseinc.com> |
Mapics XA R4.0 I can't find pre and post commands, where are they in the menus. Also in the backup to tape options, the end of tape option choices I have are 0-Unload, and 1=Rewind. Does this happen after the Mapics backup, or after the post command? Mark Murphy STAR BASE Consulting, Inc. mmurphy-Dy4KJ/[email protected] _______________________________________________ This is the MAPICS ERP System Discussion (MAPICS-L) mailing list To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mapics-l or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mapics-l.